Analysis of traditional incandescent, halogen and other dimming systems, because compared with LED lights, incandescent and halogen lamps are purely resistive devices, which means that its current waveform and voltage waveform will always be the same, when available When the silicon is used to adjust the light, the input voltage waveform deviates from the sine wave due to the change in the conduction angle of the thyristor, that is, the effective value of the input voltage is changed, and the purpose of dimming can be achieved.
FCC UL cUL
FCC UL cUL
Power Factor（Typ.）@ full load
THD（Typ.）@ full load
Efficiency（Typ.）@ full load
Inrush Current （Typ.）
20A, 50%, 1.6ms
shut down o/p voltage, re-power on to recover after fault condition is removed
≤120% constant current limiting, auto-recovery
100℃±10℃ shut down o/p voltage, automatically recover after cooling.
-40～+60℃ (see below derating curve)
Storage TEMP. Humidity
10～500Hz, 5G 10min./1 cycle,period for 60min. each along X,Y,Z axes
FCC Part 15 B
1. All parameters if NOT specially mentioned are measured at 120VAC input , rated load and 25℃ of ambient temperature.
2. To extend the driver's using life ,please reduce the loading at lower input voltage.
Protections: Short circuit / Over current / Over voltage / Over temperature
Fully isolated plastic case with terminal block style of I/O
Built-in active PFC function, comply with EN61000-3-2
Shipping and packing
1.Can i get the full price list of your led driver?
Because there are many kinds of our led driver, in order to supply you the quite right led driver you need and save your time, we would like to have your spec requirement in details, then we will recommend you the suitable led driver and quote good price for you.
2.Can you supply low THDi LED driver?
Yes, we can supply THDi less than 15%, 10%, 5%
3.Can you supply EMC test report if we need the led driver must pass EMC?
Yes, we have EMC test machine, if you need led driver EMC pass, we can test and send you full test report.