FCC UL cUL Class 2
Power Factor（Typ.）@ full load
THD（Typ.）@ full load
Efficiency（Typ.）@ full load
Inrush Current （Typ.）
20A, 50%, 1.6ms
shut down o/p voltage, re-power on to recover after fault condition is removed
≤120% constant current limiting, auto-recovery
100℃±10℃ shut down o/p voltage, automatically recover after cooling.
-40～+60℃ (see below derating curve)
Storage TEMP. Humidity
10～500Hz, 5G 10min./1 cycle,period for 60min. each along X,Y,Z axes
FCC Part 15 B
1. All parameters if NOT specially mentioned are measured at 120VAC input , rated load and 25℃ of ambient temperature.
2. To extend the driver's using life ,please reduce the loading at lower input voltage.
1.Limited voltage and constant current output characteristic
3.Low heat generation, high efficiency
4.Use long life(8000 hours) high frequency and low resistance capacitor
5.100% aging test, high reliability
6.With open circuit/ short circuit/ over load protection, safe and stable.
1.Short circuit protection:
If any wrong connection with anode and cathode at the output side, the driver will start up short circuit protection to avoid single and damage to people and the product.
2.Open circuit protection:
When the output side is in the state of no-load and open-circuit, the input side can be input normally and will not be damaged.
3.Over load protection:
Because it is constant voltage output, the current will not change when loading is within the designed current range, if loading is out of the range and generates too much heat, the driver will start up over load protection to prevent the led from damage.
1. How To Order ?
A: Step 1, please tell us what model and quantity you need;
Step 2, then we will make a PI for you to confirm the order details;
Step 3, when we confirmed everything, can arrange the payment;
Step 4, finally we deliver the goods within the stipulated time.
2 . Q: When will make delivery ?
A: Delivery Time
-Sample Order: 1-3 days after receipt of the full payment.
-Stock Order: 3-7days after receipt of the full payment
-OEM Order: 12-20days after receipt of the deposit.
3. Is it OK to print my logo on led light product?
A: Yes. Please inform us formally before our production and confirm the design firstly based on mass production after test sample well
4. How to deal with the faulty?
A: Firstly, Our products are produced in strict quality control system and the defective rate will be less than 0.2%.
Secondly, during the guarantee period, we will send new lights with new order for small quantity. For defective batch products, we will repair them and resend them to you or we can discuss the solution including re-call according to real situation.