FCC UL cUL
FCC UL cUL Class 2
Power Factor（Typ.）@ full load
THD（Typ.）@ full load
Efficiency（Typ.）@ full load
Inrush Current （Typ.）
20A, 50%, 1.6ms
shut down o/p voltage, re-power on to recover after fault condition is removed
≤120% constant current limiting, auto-recovery
100℃±10℃ shut down o/p voltage, automatically recover after cooling.
-40～+60℃ (see below derating curve)
Storage TEMP. Humidity
10～500Hz, 5G 10min./1 cycle,period for 60min. each along X,Y,Z axes
FCC Part 15 B
1. All parameters if NOT specially mentioned are measured at 120VAC input , rated load and 25℃of ambient temperature.
■ Mechanical Specification
※ Input Rubber wire 3*18AWG Black and White to be connected to AC L and N ,Green wire go ground,
※Output Rubber wire, 2*16AWG Red to LED Positive side (+) , Black to LED Negative side (-).
※The Pulse-Width Modulation (PWM) of output voltage can be adjusted through input terminal of the AC phase line(L) by connection a phase/triac dimmer.
※Usually matching with Forward phase , leading edge , Magnetic low voltage, triac dimmers, or Reverse phase, trailing edge ,Electric low voltage Dimmers.
※Please try to use dimmers with power at least 1.5 times as the output power of the driver.
1)This driver should be installed by qualified and professional person;
2)Please make sure the driver is installed with adequate ventilation around it to allow for heat dissipation.
3)Ensure that wiring is correct before test in order to avoid light and power supply damage;
4)If driver Cannot work normally, don’t maintain privately; Have any question, please contact us