30W 200-800mA triac dimmable /phase cut dimming range 0-100% IP20 plastic cover constant current led driver unit
At cold start and 25 deg C,
No damage should occurred and input fuse should not blow-up
Short circuit/Overload/Over temperature
-10°C to +45°C;20%-90%RH,Without condensation
'-30°C to +60°C
10-500Hz,2G ,X/Y/Z axis 60 mintues
Connect the line request
Input:H03VV-F 3G*0.75mm Brown&blue&kelly VDE(200mm) Output:H03VV-F 2*0.75mm Black & Red VDE(200mm)
1.All parameters NOT specially mentioned are measured at 220VAC input,rated laod and 25°C of ambient temperature.
2.Ripple&noise are measured at 20MHz of bandwidth by using a12'' twisted pair-wire terminated with a 0.1uf&10uf parallel capacitor.
3.Tolerance:includes set up tolerance,line regulation and load regulation.
1,AC 90V--265V triac dimmer and dimmer curve smoothing, according to the triac rectifier output
voltage is proportional to the curve.with Leading/Trailing edge switch functions .
2,With output short circuit protection, power protection, overheating protection function.
3,The driver cascade when using please choose appropriate power triac dimmer.
A. Choosing functions based on your application:
1. Protection function: Over Voltage Protection (OVP), Over Temperature Protection (OVP), Over Load Protection (OLP), and etc.
2. Application function: Signaling Function (Power Good, Power Fail), Remote Control, Remote Sensing, and etc.
3. Special function: Power Factor Correction (PFC), Uninterruptible Power Supply (UPS) function.
B. Make sure that the model qualifies for the safety standards and EMC regulations you need.
1.Apparent Power=Input Voltage x Input Current (VA)
2.Real Power= Input Voltage x Input Current x Power Factor (W) 85H-42A From the environment friendly point, the electric power plant needs to generate a power which is higher than apparent power in order to steadily provide electricity to the market. The real usage of electricity should be defined by real power. Assuming the power factor is 0.5, the power plant needs to produce more than 2VA to satisfy 1W real power. On the contrary, if the power factor is 0.95, the power plant only needs to generate more than 1.06VA to provide 1W real power need. It will be more effective.